Driveshaft prices can vary wildly, depending on what kind of vehicle you have, which shaft you need replaced, and whether it’s a single or two-piece driveshaft. Front driveshafts are commonly between $150 and $250; the larger rear shafts start around $250 and can reach $400 and above, possibly more for a two-piece.
How much does it cost to fix a driveshaft?
Usually, the Drive Shaft Repair costs will differ based on what caused the issue and how fast it can be repaired. If you just have to replace it, that would be anywhere from $500 to $1000. However, you can also expect the cost of the parts to be around half that number and the labor costs around $200.
How does a drive shaft get damaged?
Vibrations from under the vehicle –
Worn out u-joints or bushings can cause the driveshaft to vibrate. If you don't get the u-joints or bushings serviced, it can lead to further damage to other drivetrain components. Vibrations caused by tire balance issues are speed sensitive while driveshaft vibrations aren't.
What happens if I drive with a bad driveshaft?
Yes, you can still drive with a faulty drive shaft but it is not recommended to do so for long. When part of the drive shaft snaps, you will lose power to that axle –best case scenario. The drive shaft can also fall and get wedged between your car and the ground, disabling you to make any forward movement.
Related Question how much does a drive shaft cost
How much does it cost to fix a rear drive shaft?
You can usually expect to pay between $320 and $750 for the average cost of the parts, while the cost of the labor is between $150 and $190. If you have a rear wheel or four wheel drive car, then the price of the broken drive shaft repair cost will be much higher.
How can I test my car at home?
What causes U-joints to go bad?
Some u-joints fail from normal wear and tear, especially on vehicles that are frequently used for heavy towing or off-roading. U-joints can also fail as a result of misalignment, corrosion, or excessive vibration. In fact, u-joint failure is such bad news that it's always safer to err on the side of caution.
Is the drive shaft supposed to move?
A drive shaft is a rod-like component that transmits torque from your vehicle's engine to the wheels. It's important that the shaft assembly is flexible because drivetrain axles vibrate up and down and move laterally with braking and acceleration.
How long does it take to install a driveshaft?
even a novice should have it done in about 2-3 hours taking your time and following the manual.
How important is a driveshaft?
The driveshaft is an important element of your vehicle that rotates and delivers power to the engine and gears that turns the wheels of the automobile. In addition, it creates torque that makes the car go. It also stops the vehicle. A car cannot function without its driveshaft.
How long should a driveshaft last?
While there is no set lifespan of a driveshaft, it typically can last about 75,000 miles. Keep in mind depending on the vehicle, and wear and tear you may get much less or much more.
Are drive shafts balanced?
In order for the driveshaft to be properly balanced, it must remain completely intact, so make sure that the slip yoke, U-joints, and flanges are all still connected to the driveshaft when it is removed. The driveshaft, as one unit including the slip yoke, U-joints, and flanges, is then placed on a balancing machine.