The cost of replacing ball joints is dependent on the type of car you drive. Different makes and models require different parts. The average ball joint replacement cost is anywhere from $500 to $700. Another important factor that will affect the cost is how much damage is done to the system and the ball joints.
How much does U joint repair cost?
The average price for the u joint replacement cost ranges between $190 and $260 for the replacement, while the labor on this job runs between $170 and $210 on aveage, with the parts ranging between $20 and $50. Keep in mind, the average u joint replacement cost will vary depending on the type of vehicle you have.
How much does it cost to change a universal joint?
You will pay somewhere between $190 and $260 for replacement of the universal joint. The labor on this job should cost you between $170 and $210, while parts can run between $20 and $50.
How hard is it to replace AU joint?
Replacing these joints is a fairly straightforward job, though it takes some prior experience. To begin, you'll need a universal joint pressing tool. You can also take advantage of the loaner tools program at your local Advance Auto Parts store. Then follow these step-by-step instructions on how to change U joints.
Related Question How much does it cost to fix AU joint?
How do you know when AU joint is bad?
How long should AU joint last?
U-joints can last decades, or they can break when the vehicle is still new. That's why it's a good idea to check the u-joints at every oil change. A typical rear wheel drive vehicle has 2 or 3 u-joints. Some vehicles with a long wheel base, such as buses, have 3 or more u-joints.
What causes U joints to fail?
This usually happens because of corrosion, excessive jolting or vibration, or because the bolts were not properly torqued into place. A worn or cracking transmission or differential housing can also cause this. Of course, u-joint failure isn't limited to these three causes.
How do you change AU joint?
How do you remove AU joint from drive shaft?
How do you inspect an AU joint?
How do you know if your carrier bearing is bad?
Spinning or Grinding Noise Under the Vehicle
If you hear a spinning or grinding noise underneath the cabin of the vehicle, it could be a bad carrier bearing if the internal bearings are worn or if the carrier bearing or u-joints are binding and resisting as they turn.
Can AU joint cause vibration?
Vibrations
A vibration caused by wheel imbalance will have a consistent, steady vibration when the vehicle is in motion; a U-joint failure will cause vibration when both accelerating and decelerating but the vibration will stop when your vehicle is not moving, even if you gun the engine.
Can you over grease AU joint?
There is no such thing as greasing a u-joint too much. If you don't like the grease getting all over the frame, make yourself a splatter shield out of sheet metal.
How much does it cost to replace rear U joints?
The average cost for a u joint replacement cost is generally between $222 and $275 for most cars. Labor costs are estimated to be between around $100 and $126, while the parts are more expensive, ranging between $123 and $149.
When should a driveshaft be replaced?
While there is no set lifespan of a driveshaft, it typically can last about 75,000 miles. Keep in mind depending on the vehicle, and wear and tear you may get much less or much more.
How does AU joint work?
Why do drive shafts break?
Usually drive shaft issues can be attributed to aftermarket engine modifications (more torque) or tires (more traction, and thus a higher peak torque through the shaft). In both those cases slight twisting of the shaft near the failure point will be visible.
How do I change my AU joint without a press?
How much does a driveshaft cost?
Driveshaft prices can vary wildly, depending on what kind of vehicle you have, which shaft you need replaced, and whether it's a single or two-piece driveshaft. Front driveshafts are commonly between $150 and $250; the larger rear shafts start around $250 and can reach $400 and above, possibly more for a two-piece.
How long does it take to fix a drive shaft?
That's very difficult to answer due to the multiple variables involved in removing and replacing hard to access components such as the center driveshaft on a front wheel drive vehicle like your Edge. However, in general, this type of job can often be completed in one business day; or less than 8 service hours.