Cost of Having a shop Rebuild the 4L60E If you plan on having the shop rebuild it, and you pull and bring the transmission to them, it's possible to have it done for $1000 or under. Not much under, though. If you have a shop pull, rebuild, and reinstall the transmission it can cost anywhere from $2000-$4000.
Is it cheaper to rebuild a transmission or replace it?
A transmission replace is the most expensive option when fixing your transmission. In many cases you will hear this referred to as “re-manufactured.” Basically, the manufacturer will replace parts that have gone bad with modified parts. This is an option if the transmission is too damaged to even consider a rebuild.
How long does it take to rebuild a 4L60E transmission?
Someone has to know the exact condition of your car to answer this question. The estimated time is about 8 hours. To rebuild the transmission is an additional 6 hours.
What all do you need to rebuild a 4L60E transmission?
Related Question how much does it cost to rebuild a 4l60e
How much is a 4L60E transmission?
Compare with similar items
| This item 4L60E 4x4 Stage 2 - Heavy Duty, Tow, Haul, Four Wheel Drive, 500 HP | 4L60E 4x4 Z71 1995 1996 1997 Stock Remanufactured Transmission Chevy, GM, GMC | |
|---|---|---|
| Price | $1,899.00 | $1,799.00 |
| Sold By | Patriot Transmission & Performance | Patriot Transmission & Performance |
Is it worth rebuilding a transmission?
Rebuilding a transmission can save you a lot of money over the short-term, while keeping car payments out of your monthly budget. For many, rebuilding their transmission is worth the initial cost. Rebuilding a transmission may cost you twenty-five hundred dollars or more, which is a significant chunk of change.
Is it worth rebuilding a CVT transmission?
In conclusion, as parts and special tools (where needed) become available and affordable, rebuilding CVTs will become a more-enjoyable and profitable experience. Until that time, caution is required as to how to proceed, as you are not in business to lose money.
What causes a 4L60E transmission to slip?
Internal mechanical failure will be the cause of transmission 'slippage'. Your transmission fluid will appear at a low level. This is generally due to a fluid leak somewhere which will result in the transmission slipping.
Can I replace my 4L60E with a 4L80E?
The 4L80E has been used in a number of 1/2-, 3/4-, and 1-ton GM trucks over the years. Upgrading from the 4L60E to the 4L80E is akin to going from a Dana 44 axle to a Dana 60--you'll add some weight, but also add durability.
How much does it cost to rebuild a transmission yourself?
Rebuild kits are usually priced around $50 to $300, depending on what parts are included and the quality of them. Doing it yourself will cost less than $500 in most cases, although you need the experience and knowledge to do it right.
How much power can a 4L60E handle?
Their Stage 2 Pro Race transmission can handle gobs of power while their Invincible Black Edition 4L60E trans can support over 1,000 ponies.
How do I shift my 4L60E without a computer?
Can a transmission last 300k miles?
Without service and maintenance, some transmissions can fail in as little as 100,000 miles. With care and service, transmissions can last 300,000 miles or more. Scheduled fluid changes, transmission inspections, and band adjustments can save you thousands of dollars down the line from a premature transmission failure.
Is the 4L60E reliable?
In short, the 4L60E is an excellent transmission that continues to be improved. It's one of the most popular automatic transmissions in America, and there are still millions of them in use. Gearstar builds high performance transmissions that are handbuilt in our shop.
What years was the 4L60E used?
What years does 4L60E transmission fit?
| Year Ranges | Transmission | Pan/Filter |
|---|---|---|
| 1994-1996 | 4L60E | Shallow |
| 1997 | 4L60E | Shallow – Early Deep – Late |
| 1998-2000 | 4L60E | Deep |
| 2001-2003 | 4L60E/4L65E | Deep |
What cars did the 4L60E come in?
What Vehicles Have A 4l60e Transmission?
Can a stock 4l60e handle 500hp?
A well built 4l60e can handle some serious power. We have cars running 500-600 and 700 rwhp as the power increases of course the odds of failure do increase but we have had very good results. Generally a stock rebuild is not adequate for much more than general bolt ons however.
What does a Corvette servo do in a 4l60e?
Why Put A Corvette Servo In A 4l60e? The corvette servo will give your 4l60e 50% more apply pressure, meaning it will allow for a much firmer shift. This helps prevent the transmission from slipping under heavy load, such as racing or towing, and is highly recommended for any high performance application.
What transmission is better 4l60e or 4L80E?
Without a doubt the 4L80E is the more powerful of the two transmissions. Vehicles with powerful engines, such as big trucks for towing or high speed cars for racing, require a 4L80E rather than a 4L60E as the power of the engine is likely to break smaller, less powerful transmissions.
How long does it take to break in a rebuilt transmission?
Drive 300-500 miles, starting with low power output and gradually increasing. While driving you should be periodically running through the gears, up-shifting and down-shifting.
Should I rebuild my transmission or buy a new one?
Generally, if a repair estimate costs more than a rebuild, then the rebuild is the service to go with. If the cost of a replacement transmission costs less than a repair or rebuild, then the replacement is the best alternative. Most importantly, you should only use the services of transmission professionals.
Is rebuilding a transmission hard?
Difficulty Level. Rebuilding an automatic transmission is generally regarded as a difficult undertaking because the repair shop must be familiar with your specific type of transmission. Automatic transmissions vary widely from one vehicle to the next and each requires totally different parts and tools to rebuild.
How much does it cost to have a CVT transmission rebuilt?
A CVT transmission rebuilds costs between $3500 and $8000 on average. The cost varies depending on the vehicle's manufacturer and model. If rebuilding the CVT isn't an option, the machine must be replaced with a new one.
How long does a rebuilt CVT transmission last?
On average, a rebuilt transmission is expected to last between 30,000 – 50,000 miles. If the work is done extremely well and regular maintenance is performed, a transmission rebuild can last as long as the original transmission (120,000 – 200,000 miles on average).
Does anyone rebuild CVT?
Advance Transmissions Is One Of The Few Transmission Rebuild Shops In The Country That Is Certified To Rebuild The CVT Transmission! Therefore, After Hundreds Of Hours Of R&D We Are One Of The Only Providing A 3 Year Or 100K Warranty!
How many shift solenoids does a 4L60E have?
There are 2 shift solenoids in a 4l60e (1-2 and 2-3), and both control up and downshifts with fluid passing through them when commanded to do so by the computer. However, when they go bad, you will notice very quickly.
Can you fix a slipping transmission?
If your transmission problem isn't due to worn out bands or fluid leaks, then you either need to replace the clutch, the worn out gears, the solenoids or the torque converter. Any of these is a costly repair which is best performed by a mechanic with little you can do about it.
Can I put a 700R4 in place of a 4L60E?
No 700R4 transmissions were ever controlled by the ecm. The lockup function is grounded with the ecm, but not the shift points like the 4L60E that replaced it. Any 700R4 will work in any application.
Are v6 and v8 4L60E transmissions the same?
The 4L60E in the NNBS is identical except the harness in 2009-2013. 2007.5-2008 are the exact same regardless if is v6 or v8. The converter or flexplate may be different tho.
Will a 6.2 bolt up to a 4L60E?
Yeah, it will bolt up fine, but you won't be able to make it shift. The 4L60E was electronically controlled and if you don't have the controller it won't work.
How much does it cost to rebuild a Chevy transmission?
Average Cost of Rebuild, Repair, and Replace: According to Transmission Repair Cost Guide readers, the average cost of transmission replacement ranges from $1800 to $3400. A used/salvage transmission ranges from $800 to $1500, a rebuilt transmission from $1100 to $2800 and a remanufactured from $1300 to $3400.