The sensor is located on the back of the engine, near the firewall, near the ignition module. Remove the retaining bolts, using a socket, then pull the sensor off the engine. Lubricate the new O-ring with engine oil, then slide it on the new sensor, then install the new sensor and tighten the bolts to 71 inch-pounds of torque.

How long does it take to install a crankshaft sensor?

How long does it take to install a crankshaft sensor? The engine still may run poorly, Either way find a good mechanic, one who specializes in engine performance, and set an appointment – the sooner the better. In most instances, this repair should take no longer than one day.

How do you relearn a crankshaft sensor without a scanner?

  • Turn off all of the accessories.
  • Accelerate the vehicle to 55 mph at part throttle.
  • Cruise at 55 mph for another 5-6 minutes.
  • Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute.
  • What is a relearn procedure?

    The three types of relearn procedures are auto relearn, stationary (manual) and OBD. Some vehicles may use a combination of two or more relearn types. Indirect TPMS systems use an initialization procedure which may require a TPMS tool to figure out the steps involved to reset the system.

    Related Question how to install a crankshaft sensor

    What is code P0315?

    P0315 is the OBD-II generic code for a fault involving the crankshaft position system. The signals from the crankshaft are received by the powertrain control module. The sensor connected to the vehicle's crankshaft stays in time by transmitting voltage signals to the powertrain control module.

    Car Shakes When Stopped Check Engine Light On
    How Much Does It Cost To Fix A Radiator Leak