Begin with the vehicle on level ground, parking brake on, engine off. Step 1 - When replacing a mass air flow sensor, first locate the sensor which is positioned in the air intake tube between the air filter housing and throttle body. Step 2 - Release the safety clip and gently pull the connector from the sensor.
How much does it cost to replace a mass air flow sensor?
The Average Mass Air Flow Sensor Replacement Cost Ranges from $240 to $330 Depending on if You Go to the Mechanic or DIY. Cost to DIY: $3 to $240, depending on whether you clean the MAF first or replace it. Urgency: Perform this service within a month to avoid vehicle damage.
Can I clean my mass air flow sensor?
We recommend that you clean the MAF sensor every time you change your air filter. Spray 10 to 15 spurts of the mass air flower cleaner onto the wire or plate. Don't scrub the parts; you may break the wire or damage the plate. Allow the MAF sensor to dry completely before reinstalling it in the air duct.
How do you fix a mass airflow sensor?
Related Question how to replace the mass air flow sensor
Can a new mass air flow sensor be bad?
A faulty mass airflow sensor will cause problems similar to low compression or low vacuum, and will also show symptoms similar to when your vehicle has low fuel pressure from a faulty fuel pump. Here are some of the most common symptoms of a faulty mass airflow sensor: The engine is very hard to start or turn over.
Will a bad mass air flow sensor throw a code?
A bad mass air flow sensor causes various driveability problems, such as a no-start, stalling, lack of power and poor acceleration. A bad or contaminated mass air flow sensor can cause trouble codes P0171 System Too Lean and P0144 System Too Lean.
How much is a air flow sensor cost?
Many mass air flow sensors will cost around $100–$150, however some will reach upwards of $400 — especially in higher end German makes. Most of these sensors sit on the air induction system, so installation will not be very expensive, usually around $20–$50.
What causes mass airflow sensor problems?
Contamination is a key reason why MAF sensors fail and require replacement. As air, dirt and other debris get into the sensor, the parts become contaminated and fail. Drivers often notice sluggish performance, rough idling, poor acceleration or even stalling.
Can a bad mass air flow sensor cause loss of power?
As a result, a bad mass air flow sensor causes various driveability problems, including a no-start, stalling, lack of power and poor acceleration. In addition, a faulty mass air flow sensor might cause the Check Engine or Service Engine Soon light to come on.
How long does a mass airflow sensor last?
Mass airflow sensors (MAF) have no expiration date. They are not included on the manufacturer's scheduled maintenance list of things to replace based on mileage, like spark plugs or filters. They can remain in service indefinitely as long as they continue to function correctly.
Is there a fuse for the MAF sensor?
There is a fuse for the maf sensor, but it is not the same one that runs most of the other stuff on that side of the engine bay. The code you get is for a dead maf, usually when the fuse pops.
What should MAF be at idle?
With the engine at idle, the MAF's PID value should read anywhere from 2 to 7 grams/second (g/s) at idle and rise to between 15 to 25 g/s at 2500 rpm, depending on engine size.
What codes can a bad MAF sensor cause?
Mass Air Flow Sensor Symptoms
Some of the most common MAF-related DTCs include P0100 through P0103. A faulty MAF sensor can also trigger other codes, such as those pertaining to an air/fuel ratio imbalance or an engine misfire.
Where is a mass airflow sensor located?
MAF sensors are located between the air filter and the throttle body and are responsible for measuring the amount of air entering the engine. Most vehicles have a hot wire MAF sensor.